The Sony SRS XB23 speaker charging.
This piece covers how to charge Sony speaker, the common variety. Do this easily through the USB or barrel power in port. Any Sony speaker has one somewhere. The water resistant models have it behind a flexible sealing door, shown in the pictures below. Note that you can still play your speaker as it charges, without lengthening the recharge time very much.
First, many models of Sony speaker come with a suitable charger. So use the one that accompanies the speaker if you can, for best results. But if you lose yours, then pick a strong enough adapter. In this example, we use the Sony SRS XB43 speaker. And this particular model requires 15 watts (5 volts at 3 amps max).
Now once you’ve chosen the right charger, plug that into a working AC outlet. Finally, plug the DC end into the speaker.
Then, after four to six hours, your speaker finishes charging. So it’s ready to play once more. The play time varies among the different speaker models. But it ranges from 10 to 24 hours roughly.
The Key Power model HDD15-3-PD USB power delivery system works well on most Sony speaker models.
Use a fingernail, dime, penny, or small screwdriver to work open the waterproof port door if yours has this. Ours does indeed have this here. Also, be careful not to scratch the fragile seal around the inside edge of this door.
Prying open this door exposes the charging port inside, as shown next, pointed at by the red arrow.
Note that most models of the Sony speaker still charge while running. But the speaker might charge a bit faster when switched OFF. This depends on how much current your charger provides.
Then, plug the matching end of the charge cable into the Power Input port, as seen in the next shot.
Warning: Only use the correct port for charging the speaker. On Sony speakers that have this, do not use the output port. This is for the power bank function only, for powering other devices. In this example, feeding external power into THIS port will not only fail to recharge the battery. But this could also damage the electronics inside.
If your charger has a unpluggable cable, then be sure to connect the matching end to it. Note though that the included adapter with the speaker here has a permanently attached cord. So skip this step if that’s what yours has.
Then connect the mains end of the supply into a working AC outlet. We plug ours here into a surge protecting power strip.
The status lamp lights up solid orange. These speakers generally have no battery status gauge that shows percentage of charge. But the glowing lamp means that charging is underway.
Full battery charging is complete when the CHARGE lamp shuts off, as shown next.
Note that unless you seat this cap securely on so equipped Sony speakers, water may soak the power input port. And, since water and electronics generally do not mix, this might damage the sensitive contacts inside it. So be sure to press this door closed with enough force to fully seat it, for max moisture protection.
We have now fully charged our speaker.
Finally, repeat this recharging whenever the speaker runs dead, to keep the battery in top condition for years to come. But do not let the battery sit, in a discharged state for long, as this could shorten its life.
While fixing squeaky wooden glider rocking chairs, we needed a socket set that has popular…
Here we talk about the Echo Dot 3rd Gen power cord that comes with this…
In this post, we give the iPod Nano 3rd Generation Factory Reset routine to put…
In this post, we give the iPod Nano 3rd Generation Reset to Factory Settings routine,…
In this post, we describe How to Factory Reset iPod Nano 3rd Generation to put it…
In this post, we give Factory Reset iPod Nano 3rd Generation routine to put it…