How to tell if Sony SRS XB12 wireless BT speaker is charging? This extra bass speaker has an orange LED light on its rear side panel, near the bottom, as shown in the picture above. This light flashes orange when the battery is nearly dead. So it also tells battery level (to a degree). To see if the XB12 is charging, check out this lamp. We explain how to read it next.
Of course, you can know that the speaker is NOT charging with no power cable plugged in.
When the speaker is OFF, you can tell if the Sony SRS XB12 is charging if this light glows steady orange. This solid glow occurs while charging, when the speaker is either running, paired, OR OFF. When not connected to a charger, this light blinks when the battery has about run entirely out of power.
If the SRS XB12 CHG lamp glows steady or flashes when the power cord is connected, then the speaker may not be charging. So you should check that your USB cable, adapter charger, and power source are in working order. Try a new adapter or a cord you know is good. You want this light glowing solid to know for sure that the XB12 is charging.
Additionally, the bottom of the Sony SRS XB12 warms slightly as the speaker charges, as do most of the charger adapters you run it with. This heating is a great sign to tell if the speaker is indeed charging.
As speaker charging advances toward finish, the CHG LED continues glowing. But unlike some of the higher grade wireless speakers, the XB12 gives no reading of just how far along its recharging is, just that the recharging is in progress.
The battery charge cycle completes when the CHG LED goes dark.
Even with the charger cord still plugged in, and when the XB12 is powered down, this lamp stops glowing entirely when the internal battery is full, as shown in the last picture above. The speaker no longer recharges then, and this light shuts off.
With the USB cable disconnected, we cannot know just by reading the CHG or Status LEDs, just how much the SRS XB12 actually recharged, only that it did charge some. It probably did recharge to full though, as long as we waited until the CHG lamp stopped glowing before unplugging the charger.
Explains the Wonderboom connect 2 speakers routine, so that they both play the same audio…
This post shows how to sync the Wonderboom with common Bluetooth devices. So first, start…
This post shows how to connect Wonderboom with common Bluetooth devices. So first, start with…
The Honeywell thermostat waiting for equipment condition sometimes happens on these smart thermostats. So these…
When your JBL Boombox won't turn ON, this has several possible causes. Either it is…
You can adjust the bass of the JBL Flip 5 speaker by turning ON and…