Top view of the JBL Xtreme 2 speaker, connected to power, and charging.
You can change how loud the bass is on the JBL Xtreme 2, by turning on its super bass mode. When switched on, bass mode makes the passive bass radiators vibrate much more. So it adds a low rumble quality to the playing program, that travels pretty far from the speaker.
By default, this speaker has its bass mode turned ON after a reset. Note that this mode indeed adds some extra bass. But it also adds a little more treble as well.
You can turn bass mode ON by pressing the Volume Down (-) and Bluetooth buttons. Hold them in for about ten seconds. Then release them whenl the Power and Connect buttons light up white.
E.g. Find all these buttons on the top of the speaker, as shown in the picture above.
To turn low frequency mode back on, again, press the Volume Down and Bluetooth buttons. Then hold them in until the Power and Connect buttons light white. Finally release them. When the buttons inside the circled oval light white, the bass mode is in effect once again.
The drivers really thump when you switch ON the low frequency mode. So use caution in how loudly you play this speaker. Indeed the extra bass may damage the drivers if you’re not careful. If the bass is crackling, tapping, or distorting, then turn it down !
Shows how to pair Amazon Echo to Bluetooth speakers. These include the generation 1 and…
Many speakers including this one, feature a status light that glows red while charging /…
Many speakers, including this one, feature a status light that glows red while charging /…
Here we cover the Amazon Echo Dot 3rd generation power cable specs. This is the…
The Sony SRS XB32 speaker charging indicator is a small LED light in the back…
Here we cover the Echo Dot 3rd generation power adapter specs. This is the wall…