JBL Charge 5 Charging

You can recharge the JBL Charge 5 through the USB-C charging port at the rear of the unit. To summarize these JBL Charge 5 charging directions: First, choose a right size USB power adapter, which we detail below.

Next, connect the Black USB-C cable included with the 5 between the Charge 5 and the power adapter you’re using. Then plug the adapter into a working wall outlet. Finally after four to five hours, your speaker will fully recharge. Then, you can play it again for up to twenty hours roughly, before you must recharge it again.

JBL Charge 5 Charging: Step by Step

1. Choose Right Size Charger

The charger you use should be able deliver 15 watts (5 volts at 3 amps) for fastest recharging.  Plus, pick one with a female USB-A output port so that the included cable with the 5 will fit it.

For this demo though, we use the adapter that came with our Charge 5. But though it doesn’t output quite the max current, the unit still charges in about the same time.

2. Plug in the USB-C Cord to Continue with JBL Charge 5 Charging

Insert the small end of the black USB-C charging cable into the matching port in the 5.

3. Plug the Other End of the Cord into the Power Adapter

Next, connect the A end of the USB charge cable to your USB power supply of choice.

4. Plug that Power Adapter into a Working Outlet to Continue with  JBL Charge 5 Charging

Now that the charger is present, we plug it into a working AC outlet.

At least part of the battery status gauge bar lights up when you apply enough USB power. As charging progresses, as shown in the next picture, more of this bar lights up, starting with the bottom.

5. Allow Charging to Continue Until the Battery Meter Bar Goes Dark

Recharging is almost complete when all but the top part of the battery gauge glows solid. The topmost part keeps flashing though, for a few minutes more while the system tops off the charging.

After that, the battery charge cycle finishes when this gauge goes out.

6. Unplug the USB-C Charge Cable

7. Done with JBL Charge 5 Charging !

We have now fully charged the 5. To further confirm this, check out the battery meter just after turning on the unit afterwards. The entire meter bar should now glow, meaning that the speaker is at full charge.

Repeat this charging every twenty hours of music play, to keep its battery in top working condition. In fact, we charge ours when the battery gauge shows only one light glowing.

Other Posts About the JBL Charge 5

1. 1. How to Tell if the Unit is Charging
   2. Charging Time
   3. Infinity Button Explained
   4. Bluetooth Pairing Directions
   5. How to Check Battery Level

References for JBL Charge 5 Charging

1. 1. JBL Charge 5 Official Product Page
   2. Where to Buy the JBL Charge 5