JBL Clip 3 Charge Time

JBL Clip 3 waterproof bluetooth speaker, front view.

Here we discuss the JBL Clip 3 charge time and how to maximize it. You charge this speaker via their covered micro USB charge port. And to get the quickest charge time and fullest charge when the speaker runs low on power, be sure to use a medium to high current USB charger. Also be sure to charge the speaker completely whenever possible, as well as run it completely dead during each charge cycle.

JBL Clip 3 Charge Time: How Long to Fully Recharge

According to the specs for this speaker the time it takes to charge the JBL Clip 3 Bluetooth speaker is three hours (3.0 hours).

JBL Clip 3 bottom view, with USB charge cable plugged in.

How Long it Plays Per Full Charge

On a complete charge, the JBL Clip 3 can play for up to three (3) hours, due to its 1,000 MaH, 3.7 volt lithium ion polymer battery. But when you play this BT speaker loudly, especially with extra bass, you will see somewhat shorter lasting power.

We’ve seen the JBL Clip 3 run dead in around two hours when played at louder volumes. So to get the longest charge time from it, power saving is key. Just play it only as loudly as you need to, to hear it well throughout your listening space.

The Status lamp glowing red during charging.

The Charge Time Gets Smaller as the JBL Clip 3 Ages

If you own this speaker over a few to several years, you may notice that the time it plays from a single charge shrinks as the speaker gets older. This is normal for devices like this one, that rely on lithium ion batteries.

But by exercising the battery, you can slow this charge fall off.

To exercise the JBL Clip 3, run the battery dead and charge it again every three to six months when not in use.

Also, we recommend that you not leave the speaker plugged into a charger once it has reached full charge. Right after the charging lamps completely go out, disconnect the speaker as soon as you can, to avoid overcharging it and damaging the battery.