Right side view of the JBL Flip 5 speaker.

JBL Flip 5 Not Charging, How to Fix

Most JBL Bluetooth speakers, including the Flip 5, offer truly portable operation via their lithium ion batteries inside. And when said battery dies, you can recharge the speaker with an AC or car adapter. Sometimes though, you may find that the JBL Flip 5 is not charging fully, or at all, even when you connect the adapter to home or auto power, and then to the speaker.  To solve that, we offer information here to help.

How to Tell that the JBL Flip 5 is Not Charging

Among the ways you can tell that the Flip 5 is not charging, is by reading the battery status gauge on the top of the speaker.  Now the meter changes from white to pulsing red during play, to alert you that the battery is running low.

But there’s a problem if this flashing keeps going, even when you attach the charger.  Why?  Because the battery gauge should change at this point though, to blinking white, when you apply charger power.  When the gauge stops flashing red, this means that the speaker is getting some power from the adapter. But if the red blinking continues, then correct recharging is likely not occurring.

You can also feel the power supply’s case ten or fifteen minutes after connecting it to the speaker.  Then, it should feel warm.  The same with the speaker too.  The speaker itself indeed heats up a little during correct recharging also.  But if you detect no warmth, then again, the JBL Flip 5 is likely not charging.

Moreover, the battery gauge normally shows battery recharging status.  I.e. As long as charging continues, one of the progress lights in the meter flashes white.  And, as mentioned, the gauge fully darkens when charging is done.  But if the meter still blinks after several hours on the charge, then chances are, recharging is not working correctly.

Thus when you notice that the speaker is not recharging, even though it should be, you’ll want to check out why, and figure out how to fix this problem.  So in this piece, we offer reasons why the JBL Flip 5 may not charge when you connect it to power.  Then we give possible fixes for this seen-often difficulty.





 JBL Flip 5 Not Charging, Reasons and Fixes

As we stated above, it’s normal that the battery status gauge pulses red when the battery inside is almost dead.  But again, the light should switch to a blinking white when you connect the speaker to a working charger, and the charger to a power outlet, and battery recharging begins.

Picture of the red light on the JBL Flip 5 speaker flashing.
JBL Flip 5 red light flashing.

Normally though, this gauge stays dark except for just after you press any button on the speaker and the speaker is ON.  In that case, the gauge lights white when the battery is not getting near dead.  It can look as follows.

Picture of the JBL Flip 5 powered ON, held in hand.
JBL Flip 5 powered ON, held in hand.

Or, if the speaker is OFF when charging starts, and you don’t turn it ON during charging, then once recharging finishes, the battery level meter goes dark. See this in the next picture.

Picture of the JBL Flip 5 speaker with the battery meter dark.
JBL Flip 5 with the battery meter dark.

If the meter light does not change to flashing white when you plug the charger into the speaker, then several things might cause this. We list these below thus.

1.The Power Outlet May Not Be Energized

The Problem

The AC or car adapter for the JBL Flip 5 may not output any energy because it is not receiving any to begin with. This can happen due to a defective circuit, tripped breaker, blown fuse, faulty wiring, power failure, and similar issues.

The Fix

Check that your outlet has power by plugging in a test light or other device.  Then, reset circuit breakers if tripped, and if the outlet has a light switch that controls it, then be certain that that switch is in the ON position.  Or, simply try a different outlet.

2. The USB Adapter is Broken or Too Small

The Problem

The JBL Flip 5 not charging can also happen because the adapter is outputting SOME but not FULL amperage to fully recharge the speaker, even though its receiving power from the outlet.

Now as these adapters age, their output energy can fall off over time. So this power supply might not deliver the correct amount if it is very old.   So you may see the speaker’s battery status gauge start flashing white, but never never go dark, as you would normally see when correct charging finishes. Please note that this speaker needs 3 amps at 5 volts (15 watts) from the power supply to fully recharge in the specified time of 2.5 hours.  Yet charging will likely not go as fast as we hope if the charger does not deliver on these requirements.

The Fix

The solution is to replace the adapter, preferably one that has a USB-C plug and delivers at least 5 volts at 3 amps). Most common USB-C power supplies meet these power requirements. But check and be certain that the one you plan to buy does.





3. The USB Charging Cable is Too Long, Too Thin, or is Broken

The Problem

The USB-C cable can limit the charging current too much, even if your power supply is working well.  This might happen with very long or thin cables.

The Fix

To resolve this, use as short a cord as workable. Or, upgrade to a thicker, higher current cable. We advise keeping cable lengths to six feet or shorter, and to select a cable that is certified to carry at least 3 amps for fastest charging.

4. The Battery in the Flip 5 is Worn Out

The Problem

As lithium ion batteries age, they lose their ability to fully charge, and the characteristics of the charge current they pull, changes as they get older.  Normally, as a battery recharges, it draws less and less amps from the charger as it fills. But in the case of cell failure, it may draw too many or too few amps, thus confusing the speaker’s charging circuits into acting like no charging is occurring.  So the battery meter shows that charging is not happening, either by never stopping its red blinking, or never changing to white when you connect the charger.

The Fix

To repair this, replace the battery. But understand that you likely will not easily get the old one out of the Flip 5. Indeed, changing the battery means that you must take the speaker apart, and this can be a daunting effort.

Also note that doing this likely breaks the moisture seal.  So the Flip 5 will no longer be safe to use, should you expose it to water afterwards.

Breaking this seal may alter the sound quality as well. So get someone to replace the battery who knows how to pick the right Flip 5 replacement. They should also be able to restore the seal to as it was, as they reassemble the speaker. A good battery should fit well inside the speaker and provide 3.6 volts at 4.8 amp hours, or 17.28 watt-hours. But we suggest using only JBL certified batteries for this speaker.

5. The Speaker Might be Defective when the JBL Flip 5 Is Not Charging

The Problem

Even if you have the proper AC USB adapter, with a working battery in the speaker, the charge current that actually gets to the battery may be too low or too high.  This can happen when the battery management system inside the Flip 5 goes amiss.  Note that these circuits read the battery status, and switch off the charging current when they deem the battery full.

But when they go off askew, the battery might see no power at all though the power supply itself is working as designed.  Thus, the speaker never recharges.  Again, in this case, the battery gauge might continue blinking white and never stop. You may also see that the speaker doesn’t play as long before running dead, if at all, until you connect the charger. Or it might not play at all, even with the charger connected.

The Fix

The best answer here, is simply to get a new JBL Flip 5.  Why?  Because the electronics in this Bluetooth speaker are quite small.  So unless you can replace the system board(s) yourself, or know someone who will do it for you, just buy another unit to save a bunch of mental tension.





Related Posts to JBL Flip 5 Not Charging

  1. How to Fix JBL Flip 4 Not Charging Problem
  2. JBL Clip 4 Not Charging, How to Fix
  3. JBL Clip 2 Not Charging, How to Fix
  4. The Clip 3 JBL Speaker is Not Charging, How to Fix
  5. JBL Xtreme Not Charging, How to Repair

Other Posts About the JBL Flip 5 Bluetooth Speaker

  1. JBL Flip 5 Software Update Instructions
  2. How to Rename JBL Flip 5 Bluetooth Speaker
  3. JBL Flip 5 Extra Bass Mode Explained
  4. Reset Bluetooth Instructions for the JBL Flip 5 Speaker
  5. JBL Flip 5 Red Light Stays On, How to Fix

References for JBL Flip 5 Not Charging

  1. JBL Flip 5 Official Product Page at harmanaudio.com
  2. Where to Buy the JBL Flip 5

Revision History

  • 2022-08-01: First posted.
%d bloggers like this: